Outdoor Cleaner

Read ALL safety and first aid instructions on container or download corresponding Data Sheet before use.
DO NOT mix with other chemicals.
Use in well ventilated areas. WARNING vapour maybe harmful.
For best results choose an overcast day with minimal wind and avoid spraying in direct sunlight.
Keep pets and children indoors.
Rinse surrounding plants and grass areas with clean water before & after use.
Avoid contact with clothing. If contact occurs, rinse thoroughly with water.
Contains Sodium Hypochlorite and may cause discolouration. Test in an inconspicuous area before use. If any discolouration is observed, discontinue use immediately.
If using on fabric, test on a small area first.
DO NOT allow spray or rinse to contact the foliage of wanted plants.
Shake contents before using.
DO NOT allow children or pets to enter treated areas until spray has fully dried.

NOT TO BE USED FOR ANY PURPOSE OR IN ANY MATTER CONTRARY TO THIS LABEL UNLESS AUTHORISED UNDER APPROPRIATE LEGISLATION.

You might be interested

READY TO USE TRIGGER BOTTLE

You are watching: Outdoor Cleaner

READY-TO-USE MOTORISED POWER SPRAYER

Rinse surrounding grass or plants before and after use with clean water.
Brush off heavy build up.
Insert motorised power sprayer hose into bottle, then screw attached cap on bottle and deploy the power sprayer.
Spray onto surface when DRY (avoiding direct sunlight).
Keep surface wet for at least 5-10 minutes.
Heavy growth will require at least 10-15 minutes and possibly scrubbing.
Re-application may be required for persistent growth.
Rinse thoroughly with a hose once time has elapsed.
Metal painted surfaces or natural fibres must be rinsed within 5 minutes.

HOSE END

Shake contents well and connect your garden hose.
Using the RINSE position on the nozzle, check tap pressure and adjust to MEDIUM-HIGH.
Using the CLEAN position, spray the area to be cleaned. Keep the surface wet with the product for 10 minutes. Don’t allow the foam to dry.
Scrub with a broom.
Rinse off thoroughly in the RINSE position.
Turn to OFF for storage. Re-application may be required for persistent growth.

CONCENTRATE

Mix in a pump sprayer at a ratio of 1:1 (1 part product and 1 part water).
Spray directly onto dry surfaces, saturating the area to be treated. Keep surface wet with the solution for at least 30 seconds, scrub and rinse off thoroughly.
Heavy growth will require at least 10-15 minutes treatment.
Re-application may be required for persistent heavy growth.
Metal and painted surfaces or natural fibres must be rinsed within 5 minutes.

SURFACE NOTES

Black Mould: Keep surface wet for at least 15 minutes, then brush and rinse off.

Timber: Keep surface wet for 10 minutes, then brush with the grain.

Colour Bond Steel: Keep surface wet for a maximum of 3-5 minutes, brush then rinse well.