Under your kitchen sink, you’ll see a curved piece of pipe. Check under your bathroom sink, you’ll see the same curved piece of pipe. It’s called a P-Trap! A P-Trap is a u-shaped bend in the drainpipe that connects a sink’s drain to a home septic or municipal sewer system. How do you know which P-Trap is the correct one for you? To determine the correct size, you must distinguish between the bathroom and the kitchen sink. When deciding which material to use, look at the existing material and replicate that in your replacement P-Trap.
Choosing the Right P-Trap
You’ll need to identify the P-Trap you’re replacing. Kitchen sink P-Traps come in 1-1/2” standard size, while bathroom sinks use P-Traps of 1-1/4” standard size. The traps also come in different material types such as propylene, ABS, brass (chrome-plated or natural), and PVC. You should use the material that is currently in place when replacing a P-Trap.
You are watching: How to Choose and Install a PVC P-Trap
How to Install a P-Trap
As we cover the steps of installing the P-Trap, keep in mind that the tailpiece should always connect with the sink drain and the shorter side past the bend should connect with the drainpipe. No matter what size or materials you’re using, the steps are the same (joining methods may be slightly different based on material.)
Read more : 5 Expert Ways to Clean Wooden Kitchen Cabinets
Step 1 – Remove the Old Drain Pipe Remove the existing assembly from the top to bottom. Pliers may be required to remove the slip nuts. The U-shaped bend will have some water in it so it may be best to have a bucket and towel close by.
Step 2 – Attach the New Tailpiece If you’re replacing the kitchen P-Trap, put the tailpiece washer in the flared end of the tailpiece. Attach it by screwing the slip nut onto the sink strainer. If you’re replacing the bathroom P-Trap, know that the sink drain starts as the tailpiece and could reach the P-Trap already. If it doesn’t reach, add a tailpiece to get the correct length.
Step 3 – If Necessary, Add a T-Fitting In a few scenarios, you may need to add a Tee fitting. A sink with two basins uses a waste T-fitting to join the tailpieces. Attach the fitting with a slip washer and nuts. Make sure the beveled sides of the washers face the threaded portion of the pipes. Apply pipe lubricant on the slip washer. It will ease installation and ensure a tight fit.
Step 4 – Attach Trap Arm Remember, keep the beveled side of the washer facing the threaded drain stub-out and attach the trap arm to the drain stub-out.
Read more : Six Ways to Add Color to a White Kitchen
Step 5 – Connect the Trap Bend to the Trap Arm
The beveled side of the washers should face the trap bend. Attach the trap bend to the trap arm. Tighten all of the nuts with a pair of slip-joint pliers.
*Never use Teflon tape on white plastic threads and fittings.
Using Your P-Trap
After installing your P-Trap, you can use your sink without any issues or worry. Over time you’ll want to perform maintenance on your P-Trap to ensure it’s performing its best and that no leaks have formed. Whether you’re installing a P-Trap on a bathroom or kitchen sink, it’s a plumbing fixture you need to have.
Source: https://gardencourte.com
Categories: Kitchens